AMPLIFICATEUR STUDIO VINTAGE DE LÉGENDE: CROWN D60 À TOULOUSE

1- Crown DC-60 Laboratory power amplifier. (Je vend toute la famille D-75, D150A, DC300A, regardez mes autres annonces) -Power output: 35 watts per channel into 8Ω (stereo), 70 watts into 16Ω (mono) -Frequency response: 5Hz to 20kHz -Total harmonic distortion: 0.05% -Damping factor: 750 -Gain: 26.3 dB -Input sensitivity: 1.75V -Signal to noise ratio: 110dB -Speaker load impedance: 8Ω to 16Ω The DC-300 is a dual channel, high power amplifier for precision amplification of frequencies from DC to 20KHz. The unit features extremely low harmonic and intermodulation distortion, very low noise, high damping factor, quality parts and workmanship.  Je m'en servais en multi-amplification active sur des PR38, du velour. The unit features extremely low harmonic and intermodulation distortion, very low noise, highest “damping factor,” and quality parts and workmanship. The unit may be wired to produce a balanced 25-volt monaural output. The amplifier is fully protected against mismatched and shorted loads by resetting V-I (volt-ampere) limiter having no obnoxious muting or program delays.   Specifications: ·       Frequency Response o   0.1dB 20Hz-20KHz at 1 watt into 8 ohms o   1.2dB 5Hz-100KHz at 1 watt into 8 ohms ·       Output Power o   35 watts per channel minimum RMS (both channels operating) into an 8 ohm load over a bandwidth of 20Hz-20KHz at a rated RMS sum total harmonic distortion of 0.05% of the fundamental output voltage. ·       Output Impedance o   Less than 15 milliohms in series with less than 3 microhenries