FLANGER PEDAL MOSSAPOTOMUS A/DA FLANGER CLONE GUITAR FX PEDA À TOULOUSE

Moosapotomus recreation of the classic 70's A/DA flanger. It's been sitting in a box a few years, half-built, hopefully someone can use it.. it's a shame for it to go to waste, one of the best flanger designs of all time. I'll never have the time to finish it unfortunately. He adapted this circuit to use the MN3007 chip and has an onboard charge pump to feed it 18V from a standard 9V supply. You would need an MN3007 chip (they are being produced again, or go NOS) and your stompswitch of choice, then just drill the enclosure and wire it up. Everything else is there - all the other IC's, pots, knobs, in/out/pwr and expression jacks, standoffs etc. Only top quality parts - Alpha, Wima, Panasonic, Bourns etc. Hammond 1590DD enclosure. All component level soldering completed and flux has been cleaned. Gold plated sockets for all IC's. This a complex a complex build, well compared to a fuzz or OD anyway. Total parts cost included here was around 70-80 euro after shipping. Build manual available from Moosapotomus site, otherwise I have the PDF file can send by email. Thanks for looking. Let me know if any questions.