INTEL PRO/1000 PT DUAL PORT GIGABIT ETHERNET PCI-E X4 SERVER EN FRANCE

Intel PRO/1000 PT Dual Port Server Network Adapter Card EXPI9402PT - TWO Gigabit Ethernet Copper Server Connections in a Single PCI Express x4 Slot. Please note: Comes with High-Profile Bracket only. P/N: EXPI9402PT KEY FEATURES: - Intel 82571GB Gigabit Controller: Enables two Gigabit connections in a single adapter, delivering increased bandwidth for slot-constrained servers and providing high performance, reliability, and low power use in a single, integrated, dual port PCI Express Gigabit Ethernet controller chip. - Load balancing on multiple CPUs: Increases performance on multi-processor systems by efficiently balancing network loads across CPU cores when used with Receive-Side Scaling from Microsoft or Scalable I/O on Linux. - Interrupt moderation: Delivers increased performance while significantly reducing CPU utilization. - Compatible with x4, x8, and x16 full-height PCI Express slots: Allows dual-port operation in almost any PCI Express server slot, except x1 slots, and allows each port to operate without interfering with the other. - Support for most network operating systems (NOS): Enables widespread deployment. - Remote management support: Reduces support costs with remote management based on industry-wide standards. - Category-5 unshielded twisted pair (UTP), 4-pair cabling: Uses existing 4-pair cabling and saves re-wiring costs. - RoHS compliant, lead-free technology. - Intel PROSet Utility for Microsoft Device Manager: Provides point-and-click power over individual adapters, advanced adapter features, connection teaming, and virtual local area network (VLAN) configuration. - Advanced cable diagnostics: Dynamically tests and reports network problems (error rate, cable length) and automatically compensates for cable issues (cross-over cable, wrong pin-out/polarity). SPECIFICATIONS: General: Product code: EXPI9402PT4 Connectors: Two RJ-45 IEEE standards/network topology: 10BASE-T, 100BASE-TX, 1000BASE-T Wiring: Category-5, unshielded twisted pair (UTP), 4-pair Adapter Product Features: Intel PROSet Utility and Intel PRO Intelligent Install for easy installation: Yes Intel lead-free technology: Yes Plug and play specification support: Standard Auto-negotiation, full-duplex capable: Yes Integrated media access control (MAC) and physical layer (PHY): Yes Includes a full-height bracket: Yes Cable distance: 100 m in Category-5 for 100/1000 Mbps; and Category-3 for 10 Mbps Network Management: Wired for Management (WfM) baseline v2.0 enabled for servers: Yes DMI 2.0 support, Windows Management Instrumentation (WMI) and SNMP-manageable SMBus support: Yes Remote Installation Services (RIS): Yes Diagnostics (loopback, testability, PHY register access): Yes Advanced configuration and power interface (ACPI) 1.0 power management: Yes Wake on LAN support over PCI Express: Yes PXE 2.0 enabled through boot read-only memory (ROM): Yes Network Operating Systems (NOS) Software Support: Microsoft Windows, Linux (non-exhaustive list). Advanced Software Features: Adapter fault tolerance (AFT): Yes Switch fault tolerance (SFT): Yes Adaptive load balancing (ALB): Yes Fast EtherChannel (FEC): Yes Gigabit EtherChannel (GEC): Yes Teaming support: Scales up to 8 connections Multiple teams: Supports 4 separate teams, maximum IEEE 802.3ad (link aggregation control protocol): Yes Test switch configuration: Tested with major switch original equipment manufacturers (OEMs) PCIe Hot Plug/Active peripheral component interconnect (PCI): Yes IEEE 802.1Q VLANs: Yes IEEE 802.3 (z, ab, u, x) flow control support: Yes TCP checksum offload — transmission control protocol (TCP), user datagram protocol (UDP), Internet protocol (IP): Yes IEEE 802.1p: Yes TCP segmentation/large send offload: Yes Interrupt moderation: Yes Technical Features: Data rate(s) supported per port: 10, 100, and 1000 Mbps Bus type: PCI Express 1.0a Bus width: x4 lane PCI Express, operable in x4, x8, x16 slots En savoir plus Collaboration commerciale.