KIT RAM DDR3 FURY HYPERX 8 GO (2X4 GO) 20 € EN FRANCE

REFERENCE Fury HyperX HX316C10FK2/8 8GB (4GB 512M x 64-Bit x 2 pcs.) DDR3-1600 CL10 240-Pin DIMM Kit DESCRIPTION HyperX HX316C10FK2/8 is a kit of two 512M x 64-bit (4GB) DDR3-1600 CL10 SDRAM (Synchronous DRAM) 1Rx8 memory modules, based on eight 512M x 8-bit DDR3 FBGA components per module. Total kit capacity is 8GB. Each module kit has been tested to run at DDR3-1600 at a low latency timing of 10-10-10 at 1.5V. Additional timing parameters are shown in the PnP Timing Parameters section below. The JEDEC stan- dard electrical and mechanical specifications are as follows: Note: The PnP feature offers a range of speed and timing options to support the widest variety of processors and chipsets. Your maximum speed will be determined by your BIOS. PnP JEDEC TIMING PARAMETERS: • DDR3-1600 CL10-10-10 @1.5V • DDR3-1333 CL9-9-9 @1.5V • DDR3-1066 CL7-7-7 @1.5V FEATURES • JEDEC standard 1.5V (1.425V ~1.575V) Power Supply • VDDQ = 1.5V (1.425V ~ 1.575V) • 800MHz fCK for 1600Mb/sec/pin • 8 independent internal bank • Programmable CAS Latency: 11, 10, 9, 8, 7, 6 • Programmable Additive Latency: 0, CL - 2, or CL - 1 clock • 8-bit pre-fetch • Burst Length: 8 (Interleave without any limit, sequential with starting address “000” only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS] • Bi-directional Differential Data Strobe • Internal(self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm ± 1%) • On Die Termination using ODT pin • Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C b'&'lt; TCASE En savoir plus Collaboration commerciale.