MAMIYA NC1000 CS LENS ADAPTER FOR FUJI X FX MOUNT - WITH APE À NICE

I bought this adapter from an american buyer (I bought it on, you can check) few months ago, but I do not have utility anymore so I sell it. Please note this is a small production so there are cosmetic flaws but it's works well and it's solid! Please watch photo carrefully. I'm here if you have any question about the adapter. This adapter is very rare and the only one available in Europe. I pay more than 65$ for it (again, you can check it). It's designed for Mamiya-Sekor CS lenses (for Mamiya NC1000/NC1000S, Sear MBX1000) to fit Fujifilm X-mount camera (Fujifilm X-T10/100/1/2/3/X-E2/3 etc.). Fast and protected shipping. How it works? I just copy/paste the explanation of the seller below : -This adapter lets you mount Mamiya NC1000 Sears Auto CS 1000MXB lens onto Fuji X FX mount cameras. Sample rear of the lens is attached. This adapter has the aperture control ring. If you are new to CS series of lens, please read the following. 1. Please place your Aperture ring in Red dot  (Auto) on the lens. 2. If you observe from the back, pressing one pin lowers aperture and also pushes other pin out. 3. The same mechanism is used in the adapter. Turning the wheel pushes the aperture and second hole is to clear the way for other pin. 4. If you observe carefully, pressing the pin is required only to the point the aperture is set. It will not go any further then that. 5. Hence when you turn aperture wheel, if you encounter slight stiffness, stop there as you pressed it sufficiently. 6. Before changing aperture on the lens, turn the aperture ring back on your adapter. For best usage, keep the aperture in red dot only and use the ring for the desired aperture.