MODEM DSP SCS PTC-II 1200-2400-9600 B EN FRANCE

SCS   PTC-II Audio input impedance:                                               47k Ω Audio input level:                                                            10mVp-p... 1Vp-p Audio output impedance:                                            330 Ω Audio output level:                                                         Max.1 Vp-p (open circuit), adjustable in 1 mV steps. Audio processing:                                                            Digitalsignal processor XC56156 clocked at 60 MHz 128 kByte additional DSP-RAM fordata and program. FSK output:                                                                        TTL-levels High - mark, Low - space. Serial interface:                                                                9-PINSub-D socket (AT type) 2400... 115200 Baud Central processor:                                                          MotorolaMC68360 QUICC 32 bit CMOS CPU clocked at 25 MHz ROM:                                                                                    Max.512 kByte, CMOS, Flash FLASH-ROM for easy updates RAM:                                                                                    static:Max. 2 MByte, CMOS, Battery Backup, expandable in 2 steps (512k, 2M). dynamic: Max. 32 Mbyte, 72-pole SIM-Module(PS/2) Real time clock:                                                                Withbattery back up. (date, weekday, hrs, mins, secs) System monitoring:                                                        Withan internal processor watchdog. Battery:                                                                               3V high capacity Lithium cell. Front panel:                                                                       Labelled.10 character LED dot-matrix alphanumeric display. A total of 30 LED´s splitinto various functional groups. Rear panel:                                                                        LabelledInput for power supply. On / Off switch. Two sockets for the Packet-Radioports. Sockets for connection to the transceiver. Socket for transceiver remotecontrol connections. Socket for the serial interface. Power Supplies:                                                               +9to +20 V DC, 1 amp max. Reverse polarity protected Fuse 5x20 mm, 800 mAsemi-time-lag The current consumed depends on the operating condition and thebuilt in Packet-Radio modems. Dimensions:                                                                      Width150 x Height 41 x Depth 190 mm Weight:                                                                                               670g Operating temperature:                                               -20to +50 °C   Modes (depending on firmware): PACTOR (I, II), MTOR,    PSK31, RTTY, Packet, CW, NavTex, SSTV, Fax and more... FEATURES PTC-II Three simultaneously available communication ports: HF and up to two VHF/UHF Packet ports Separate transceiver control port for remote operation of Icom,  Kenwood, Yaesu, R&S and SGC equipment. 32-bit system with Motorola RISC processor 68360 as CPU, clocked at  25 MHz. 16-bit Motorola DSP 56156 clocked at up to 60 MHz (computing  power: 30 MIPS) Expandable to 2 MB of static RAM. Firmware stored in flash memory. Easy update via serial RS232 link to the PC. The update is free of charge and available from    many Packet-Radio mailboxes and from Internet sites Modem tones (mark-space) and shift programmable in 1 Hz steps within all modes. Audio output-levels for all PSK- and FSK-modes programmable seperately. Equipped for FAX (AM, FM, Meteosat), SSTV, CW operation with  receiption and transmission and full compatibility to nearly all modern  PC programs. Build-in mailbox with comprehensive features of nearly 2MB maximum size (dependent on RAM installed) with common and simultaneous access from allmodes (PACTOR-I & II, AMTOR, PACKET). Battery backup for the clock and C-MOS RAM. No mail-loss when  switched off. Mail display at the frontpanel shows the operator at once if there is a new mail for him. Excellent tuning display with 15 2-color-LEDs with center-function.  The antique X-Y-tube display is not required any more. All significant link and controller stati are displayed at the frontpanel with 2-color LEDs and on the terminal-screen. 10-character dot-matrix-display for mode and other parametes as the  callsign of a connecting station and much more. Channel-busy detection displayed on the PTC-display as  well as  on the terminal-screen. DSP-filter option implemented: The PTC-II is fully usable as DSP-filter for all modes as SSB, CW and others as (denoiser) with freely programmable sets of parameters. Features: Auto-peak, auto-notch, passband-filter, inversion, delay-line, function-generator and more. Comprehensive filtering of all in- and outputs for excellent electromagnetic compatibility. HF VHF/UHF gateway and crossband digipeating with comprehensive and automated link establishment features from remote.  PACTOR goes PACKET. Hostmode, extended hostmode, CRC-hostmode. Fullcompatible to nearly all modern PC programs. Fully integratable in FBB/Winlink networking and mailingsystems   Datacontrôleur HF et VHF Equipé des cartes modem 1200/2400 b et modem DSP 9600b packet En parfait état de marche, programme sous Windows et avec documentation complète et schémas