Goko uf 0

Features: 100% brand new and high quality Specifications Size：25*52mm Diameter of end: 5mm Color：green + gold Operating frequency：0.1-2000MHz Amplifier gain： F=0.1MHz, gain=32dB F=500Mhz, gain=31dB      F=1000MHz, gain=29dB F=1500Mhz, gain=25dB F=2000MHz, gain=20dB Maximum power output：+10dBm （10mW） Power supply voltage: 6-12 VDC System impedance：50Ω Tips： 1.When working frequency is less than 600 MHZ，it get well gain flatness, can make it less than 1dB after careful adjustment. The lower frequency the higher gain consistency. 2.Amplifier working frequency of the lower limit is subject to input and output capacitor, the default value is 0.1 uF, working to 0.1 MHz. Increase the input and output capacitance appropriately,can extend the cut-off frequency, such as 10uF capacitance can work to 5KHz. 3.When the power supply voltage changes in 5-8 v, it can be used as a variable gain amplifier, gain increases with the increase of the power supply voltage, which suitable for radio frequency receive front-end circuit, using DA control power supply voltage, to control the gain of the amplifier, automatic gain control 4.When the power supply voltage in the 8-10 v, the low frequency end gain up to 30 db, at this time the amplifier has a low noise coefficient and good stability. 5.When the voltage is 12 v, reach maximum gain, the low frequency end gain of 32.5 dB Note: 1.Due to the hand measurement, there have size error about 1-3cm 2.Please be reminded that due to lighting effects and monitor's brightness/contrast settings etc, the color tone of the photo and the actual item could be slightly different Package included 1x wide-band amplifier         Le 19-janv.-20 à 00:22:39 Paris, le vendeur a ajouté les informations suivantes:

Features: 100% brand new and high quality Specifications Size：25*52mm Diameter of end: 5mm Color：green + gold Operating frequency：0.1-2000MHz Amplifier gain： F=0.1MHz, gain=32dB F=500Mhz, gain=31dB      F=1000MHz, gain=29dB F=1500Mhz, gain=25dB F=2000MHz, gain=20dB Maximum power output：+10dBm （10mW） Power supply voltage: 6-12 VDC System impedance：50Ω Tips： 1.When working frequency is less than 600 MHZ，it get well gain flatness, can make it less than 1dB after careful adjustment. The lower frequency the higher gain consistency. 2.Amplifier working frequency of the lower limit is subject to input and output capacitor, the default value is 0.1 uF, working to 0.1 MHz. Increase the input and output capacitance appropriately,can extend the cut-off frequency, such as 10uF capacitance can work to 5KHz. 3.When the power supply voltage changes in 5-8 v, it can be used as a variable gain amplifier, gain increases with the increase of the power supply voltage, which suitable for radio frequency receive front-end circuit, using DA control power supply voltage, to control the gain of the amplifier, automatic gain control 4.When the power supply voltage in the 8-10 v, the low frequency end gain up to 30 db, at this time the amplifier has a low noise coefficient and good stability. 5.When the voltage is 12 v, reach maximum gain, the low frequency end gain of 32.5 dB Note: 1.Due to the hand measurement, there have size error about 1-3cm 2.Please be reminded that due to lighting effects and monitor's brightness/contrast settings etc, the color tone of the photo and the actual item could be slightly different Package included 1x wide-band amplifier       Le 31-mars-20 à 14:26:44 Paris, le vendeur a ajouté les informations suivantes:

Features: 100% brand new and high quality Specifications Size：25*52mm Diameter of end: 5mm Color：green + gold Operating frequency：0.1-2000MHz Amplifier gain： F=0.1MHz, gain=32dB F=500Mhz, gain=31dB      F=1000MHz, gain=29dB F=1500Mhz, gain=25dB F=2000MHz, gain=20dB Maximum power output：+10dBm （10mW） Power supply voltage: 6-12 VDC System impedance：50Ω Tips： 1.When working frequency is less than 600 MHZ，it get well gain flatness, can make it less than 1dB after careful adjustment. The lower frequency the higher gain consistency. 2.Amplifier working frequency of the lower limit is subject to input and output capacitor, the default value is 0.1 uF, working to 0.1 MHz. Increase the input and output capacitance appropriately,can extend the cut-off frequency, such as 10uF capacitance can work to 5KHz. 3.When the power supply voltage changes in 5-8 v, it can be used as a variable gain amplifier, gain increases with the increase of the power supply voltage, which suitable for radio frequency receive front-end circuit, using DA control power supply voltage, to control the gain of the amplifier, automatic gain control 4.When the power supply voltage in the 8-10 v, the low frequency end gain up to 30 db, at this time the amplifier has a low noise coefficient and good stability. 5.When the voltage is 12 v, reach maximum gain, the low frequency end gain of 32.5 dB Note: 1.Due to the hand measurement, there have size error about 1-3cm 2.Please be reminded that due to lighting effects and monitor's brightness/contrast settings etc, the color tone of the photo and the actual item could be slightly different Package included 1x wide-band amplifier         Le 03-avr.-20 à 17:16:08 Paris, le vendeur a ajouté les informations suivantes:

produit Caméra dôme ip à tourelle focale fixe résolution 5 mp infrarouge 30m — ds-2cd1353g0-i (2,8 mm) — hikvision la caméra ds-2cd1353g0-i de hikvision est un modèle de plafond, destiné aux systèmes cctv ip. Elle convient parfaitement à un usage extérieur. cette caméra dôme ip est équipée d'un capteur cmos 1/2, 7", avec une résolution 5 mp. Elle est dotée d'un illuminateur ir (exir 2.0) avec infrarouge 30m. Elle donne des images détaillées, même sous un éclairage faible. Son objectif intégré à focale fixe de 2,8 mm a un angle de vision de 100 °. Cette caméra jouit de plusieurs modes de compression vidéo: h.265+, h.265, h.264+, h.264, mjpeg. Ils permettent d'alléger les flux de données et d'avoir une plus grande compatibilité avec les enregistreurs et les systèmes cctv ip. son boîtier répond à la norme ip67. Il préserve les composants électroniques de la caméra contre l'eau et la poussière. Polyvalente, cette caméra de réseau peut être alimentée par poe (802.3af) ou via une source de courant de 12 vcc. Cette caméra dôme profite aussi des atouts des appareils de la série easyip lite à laquelle elle appartient. Elle se dote d'un détecteur de mouvements et de sabotage vidéo. Elle dispose également d'un mode corridor et d'une option roi (région d'intérêt). Il faut savoir que ce modèle est géré à l'aide du logiciel client ivms 4200 et de l'application mobile hik-connect, ce qui facilite son utilisation. Principales caractéristiques du produit: caméra dôme ip 5 mp technologie de compression jusqu'à h.265 fonction wdr de 120 db pour des images claires même en fort contre-jour indice de protection ip67 technologie ir avancée exir 2.0 avec infrarouge 30 m microphone intégré uf capteur d'image 1/2. 7" cmos à balayage progressif résolution maximale 2560 × 1920 illumination minimale: 0,01 lux @ (f2.0, agc on) en couleur, 0 lux avec ir en noir/blanc objectif focal fixe de 2,8 mm logiciel et application client: ivms-4200, hik-connect fonctions: 3d dnr et blc. Générales EAN 6954273678784 Marque HIKVISION Couleur du produit Blanc Nombre de produits 1 Caractéristiques du produit Nombre de pièces de la maison Non communiqué Utilisation Intérieur Compatible animaux Non communiqué Surveillance à distance Non communiqué Accessoires inclus Non communiqué

Features: 100% brand new and high quality Specifications Size：25*52mm Diameter of end: 5mm Color：green + gold Operating frequency：0.1-2000MHz Amplifier gain： F=0.1MHz, gain=32dB F=500Mhz, gain=31dB      F=1000MHz, gain=29dB F=1500Mhz, gain=25dB F=2000MHz, gain=20dB Maximum power output：+10dBm （10mW） Power supply voltage: 6-12 VDC System impedance：50Ω Tips： 1.When working frequency is less than 600 MHZ，it get well gain flatness, can make it less than 1dB after careful adjustment. The lower frequency the higher gain consistency. 2.Amplifier working frequency of the lower limit is subject to input and output capacitor, the default value is 0.1 uF, working to 0.1 MHz. Increase the input and output capacitance appropriately,can extend the cut-off frequency, such as 10uF capacitance can work to 5KHz. 3.When the power supply voltage changes in 5-8 v, it can be used as a variable gain amplifier, gain increases with the increase of the power supply voltage, which suitable for radio frequency receive front-end circuit, using DA control power supply voltage, to control the gain of the amplifier, automatic gain control 4.When the power supply voltage in the 8-10 v, the low frequency end gain up to 30 db, at this time the amplifier has a low noise coefficient and good stability. 5.When the voltage is 12 v, reach maximum gain, the low frequency end gain of 32.5 dB Note: 1.Due to the hand measurement, there have size error about 1-3cm 2.Please be reminded that due to lighting effects and monitor's brightness/contrast settings etc, the color tone of the photo and the actual item could be slightly different Package included 1x wide-band amplifier       Le 16-avr.-20 à 09:59:54 Paris, le vendeur a ajouté les informations suivantes: