TRANSCEIVER ICOM 7800 EN FRANCE

Vends ICOM IC-7800 En parfait état de marche, peu servi (cause utilisation chaine FT1000 Mark V+VL1000) Jamais utilisé en émission, Local non-fumeur Version logiciel (firmware) 3.10 Très beau transceiver, performant Avec clavier USB et notice complète. General Frequency coverage   Europe Version    0.030– 60.000 MHz RX TX                          0.1357– 0.1378 MHz                              1.800– 1.999 MHz                              3.400– 4.099 MHz                              6.900– 7.499 MHz                              9.900– 10.499 MHz                              13.900–14.499 MHz                              17.900– 18.499 MHz                              20.900–21.499 MHz                              24.400– 25.099 MHz                              28.000–29.999 MHz                              50.000– 54.000 MHz   Mode: USB, LSB, CW, RTTY, PSK31, AM, FM Number of channels : 101 (99 regular, 2 scan edges) Antenna impedance : 50 Ω unbalanced (Tuner off) Antenna connector : SO-239×4 and BNC×2 Power supply requirement: 85–265V AC Temperature range : 0°C to +50°C; +32°F to +122°F Frequency stability : Less than ±0.05ppm                                  (0°C to +50°C, after warm up) Frequency resolution : 1Hz (minimum) Power consumption : Tx Max. power: 800VA                                    Rx Stand-by: 200VA (typ.)                                     Max. audio: 210VA (typ.) Dimensions : 424(W) × 149(H) × 435(D) mm;                        16 11 ⁄ 16 (W) × 5 7 ⁄ 8 (H) × 17 1 ⁄ 8 (D) in Weight : 25kg; 55lb   Transmitter Output power                                             (continuously adjustable) 5–200W                                                      SSB, CW, RTTY, PSK31, 5–50W                                                        FM More than –20dBm                                     AM                                                                   Modulation system SSB AM FM   Spurious emission                                                           Carrier suppression Unwanted sideband suppression     δ TX variable range Microphone impedance Receiver Receive system Intermediate frequencies 1st   2nd Sensitivity (typical) SSB, CW, RTTY, PSK31, FM 0.1–1.799 MHz 1.8–29.999 MHz 50.0–54.0 MHz AM 0.1–1.799 MHz 1.8–29.999 MHz 50.0–54.0 MHz FM 28–29.999 MHz 50.0–54.0 MHz     Squelch sensitivity (Pre-amp: OFF) SSB, CW, RTTY, PSK31 FM   Selectivity (representative value) SSB (BW: 2.4 kHz)   CW (BW: 500 Hz)   RTTY, PSK31 (BW: 350 kHz)   AM (BW: 6 kHz)   FM (BW: 15 kHz)     Spurious and image rejection ratio Audio output power RIT variable range PHONES connector EXT SP connector       DPSN modulation Digital low power modulation Digital phase modulation More than 60dB (HF bands) More than 70dB (50 MHz band) More than 63dB More than 80dB ±9.999 kHz 600 Ω (8-pin connector)     Double conversion super-heterodyne system     64.455 MHz (Main receiver) 64.555 MHz (Sub receiver) 36 kHz     0.5 μ V *1 0.16 μ V *1 0.13 μ V *2 (BW: 6 kHz at 10dB S/N) 6.3 μ V *1 2 μ V *1 1 μ V *2 (BW: 15 kHz at 12dB SINAD) 0.5 μ V *1 0.32 μ V *2 *1 Pre-amp 1 is ON. *2 Pre-amp 2 is ON.     Less than 5.6 μ V Less than 1 μ V     More than 2.4 kHz/–3dB Less than 3.6 kHz/–60dB More than 500 Hz/–3dB Less than 700 Hz/–60dB More than 360 Hz/–6dB Less than 650 Hz/–60dB More than 6.0 kHz/–3dB Less than 15.0 kHz/–60dB More than 12.0 kHz/–6dB Less than 20.0 kHz/–60dB   More than 70dB   More than 2.6W at 10% distortion with an 8 Ω load ±9.999kHz 3-pin connector 6.35 (d) mm (1 ⁄ 4 ″) 2-pin connector 3.5 (d) mm (1 ⁄ 8 ″)/8 Ω ×2 (For main and sub bands)